vertical cyclone separator adopts upper suction bag mode to change the operation of bag changing. The working mechanism of cloth bag dust collector is that the dust particles are filtered down by the dust gas passing through the filter material. The coarse dust is mainly captured by the filter material by inertial collision, and the fine dust is mainly captured by diffusion and screening. The dust layer of filter material also has the specified filtering effect. The structure design of pulse bag dust collector includes load analysis. Structural form determination, material selection, design key points and design calculation, etc., in general, the calculation can refer to the current code and supporting standard code, among which the load parameters related to the process should be determined according to the specific operating conditions of the pulse bag dust collector.

The spacing size of vertical cyclone separator depends on the technological layout of the filter bag. Generally, the diameter of the filter bag is +110 - +160mm, and the distance between the filter bag and the filter bag is 50 ~ 80mm. If the length of the filter bag is greater than 6m, the spacing of the dust removal filter bag should be greater than 60mm. The distance between the filter bag and the beam or stiffener rod of the surrounding structure shall be equal to or greater than 50mm. If the distance of pulse bag filter is too small, after the bag skin is coated with ash, the permeability of the whole box is very poor, which affects the filtration rate. And when the bag is installed, if there is a large deviation, the filter bag will collide and friction with each other and reduce the life of the filter bag. In the pulse bag type dust collector, each pulse tube is sprayed with 18 filter bags, that is, a filter set of 18 filter bags. If the length of the filter bag is more than 6m, it should be appropriately reduced.

When it comes to cleaning, few people like it. But there is no way. In the changing of the season, it feels like dust again soon after cleaning. Although with the help of vertical cyclone separator, cleaning all day is also a very exciting job. Now vertical cyclone separator shows you a few tricks to make you dust.

The cleaning process is to cut off the air duct of the clean air inlet and outlet of the chamber first, so that the cloth bag of the chamber is in a state of no air flow through (stop the air and clean the dust of the chamber). Then open the pulse valve with compressed air for pulse ash cleaning, cut off the valve closing time after spraying dust from the filter bag settled to the ash hopper, dust from the filter bag surface and then with the air flow attached to the surface of the adjacent filter bag, so that the filter bag dust, and the programmable control instrument to exhaust valve, pulse valve and ash unloading valve automatic control. Dusty gas enters through the air inlet. When it passes through the ash hopper, some large particles of dust in the gas are separated by inertial force and gravity and fall directly into the bottom of the ash hopper. The dust-containing gas enters the filter bag filter area of the middle box after passing through the ash hopper. The gas passes through the filter bag, and the dust is blocked on the outer surface of the filter bag. The purified gas enters the upper box through the filter bag mouth and then is discharged by the outlet.

vertical cyclone separator https://www.kaisenfilter.com/Cyclone-Separators.html